Most pipe leaks on board can be stopped by the crew in under an hour, with no hot work. The quickest method uses an epoxy putty stick to seal the hole and a water-activated repair tape over it. For a lasting repair, the pipe is later wrapped with epoxy coating and reinforcement tape.
Step 1: Make it safe
Isolate the line and take the pressure off if you can. If that is not possible, reduce the pressure to a maximum of 2.5 bar before you start. Repair tape alone will not seal an active leak.
Step 2: Prepare the surface
Clean and roughen the pipe around the leak with emery paper. Grease and loose rust stop the repair from bonding.
Step 3: Seal the hole with putty
Cut a piece of DuraFix FastSteel Putty Stick, knead it until the colour is even, and press it firmly into and over the hole.
Step 4: Wrap with repair tape
Dip Quick Fix Pipe Repair Tape in water for 20 to 40 seconds to activate the resin, then wrap it tightly with 50 % overlap. Nine layers give a pressure rating of 10 bar. Two times nine layers over the putty give up to 103 bar. The tape works with fresh or salt water and can be applied under water.
Step 5: Let it cure
The tape sets in 7 to 10 minutes and is fully cured after about 30 minutes. Check that the ends are tight and that there are no loose sections.
When you need a full epoxy wrap
The emergency repair keeps the system running. For corroded pipes that will stay in service, a full wrap with Super Guard epoxy coating and Super Wrap Reinforcement Tape restores the pipe for the long term. Our step-by-step procedures cover ballast pipes, sea water pipes, cargo pipes and GRE scrubber pipes.
What to keep on board
Quick Fix Pipe Repair Tape in the sizes that match your pipes (up to DN75, DN125 and DN200)
DuraFix FastSteel Putty Stick
Emery paper, gloves and a knife
See the full emergency pipe repair procedure or contact us to put together a repair kit for your fleet. More on our epoxy range at epoxy-sepcotech.com.